ビャクシンのJN0-694独学書籍の問題集

 

NO.1 -- Exhibit -user@router> show ospf database
Area 0.0.0.1 Type ID Adv Rtr Seq Age Opt Cksum Len Router 172.24.255.1 172.24.255.1 0x800000d4
182 0x22 0x59f3 36 Router 172.24.255.2 172.24.255.2 0x800000d4 177 0x22 0x57f2 36 Router
*172.24.255.4 172.24.255.4 0x800000dc 176 0x22 0x75fa 72 Network 172.24.124.2 172.24.255.2
0x80000007 177 0x22 0x7957 36 Summary 172.24.13.0 172.24.255.1 0x80000004 2370 0x22 0x3f62
28 Summary 172.24.23.0 172.24.255.1 0x80000002 471 0x22 0xdeb9 28 Summary 172.24.255.1
172.24.255.1 0x800000cb 2037 0x22 0x2bbb 28 Summary 172.24.255.2 172.24.255.2 0x800000cc
487 0x22 0x19ca 28 Summary 172.24.255.3 172.24.255.1 0x80000003 140 0x22 0xb2f9 28 OSPF AS
SCOPE link state database Type ID Adv Rtr Seq Age Opt Cksum Len Extern *1.47.82.0 172.24.255.4
0x80000002 1037 0x22 0x4225 36 Extern *100.0.0.0 172.24.255.4 0x80000001 2643 0x22 0xfc88 36
user@router> show ospf neighbor Address Interface State ID Pri Dead
172.24.124.2 ge-0/0/1.0 Full 172.24.255.2 128 36
172.24.124.1 ge-0/0/1.0 Full 172.24.255.1 128 30
user@router> show ospf interface ge-0/0/1.0 extensive Interface State Area DR ID BDR ID Nbrs ge-
0/0/1.0 PtToPt 0.0.0.1 0.0.0.0 0.0.0.0 2 Type: P2MP, Address: 172.24.124.4, Mask: 255.255.255.0,
MTU: 1500, Cost: 1 Adj count: 2 Hello: 10, DeaD. 40, ReXmit: 5, Not Stub Auth type: None Protection
type: None Topology default (ID 0) -> Cost: 1
user@router> show route protocol ospf table inet.0
inet.0: 11133 destinations, 11135 routes (11133 active, 0 holddown, 0 hidden)
+ = Active Route, - = Last Active, * = Both
224.0.0.5/32 *[OSPF/10] 1w0d 00:01:14, metric 1 MultiRecv -- Exhibit -
Click the Exhibit button.
Referring to the exhibit, why are the OSPF routes missing from the routing table for this router?
A. MTU mismatch with the neighbor
B. no Type 4 LSAs in the OSPF database
C. incorrect IP address configured on the interface
D. mismatching OSPF interface type with the neighbor
Answer: D

JN0-694復習対策   

NO.2 An end user on interface ge-0/0/1.0 is trying to receive a multicast stream for 232.0.0.1 sourced
from but is not receiving it. You use the show igmp group command and do not see this group in the
list. You enable traceoptions for IGMP and find the following IGMPv3 report from the end user's host:
Jun 10 13:11:03.577641 RCV IGMP V3 Report len 16 from 192.168.1.13 intf ge-0/0/1.0
Jun 10 13:11:03.577984 Records 1
Jun 10 13:11:03.578027 Group 232.0.0.1, type IS_EX, aux_len 0, sources 0
Which configuration change is required to allow the group to be added in the router?
A. set protocols igmp interface ge-0/0/1.0 promiscuous-mode
B. set routing-options multicast ssm-groups 232.0.0.1/32
C. set routing-options multicast asm-override-ssm
D. set protocols igmp interface ge-0/0/1.0 group-limit 2
Answer: C

JN0-694試験解説   

NO.3 -- Exhibit -user@router# show class-of-service
classifiers {
inet-precedence ipp-test {
import default;
forwarding-class best-effort {
loss-priority low code-points be;
}
forwarding-class expedited-forwarding {
loss-priority low code-points af21;
}
forwarding-class assured-forwarding {
loss-priority low code-points af11;
}
forwarding-class network-control {
loss-priority low code-points nc1;
}
}
}
interfaces {
ge-* {
scheduler-map map-test;
unit * {
classifiers {
inet-precedence ipp-test;
}
rewrite-rules {
inet-precedence ipp-rw-test;
inet-precedence default;
}
}
}
}
...
rewrite-rules {
inet-precedence ipp-rw-test {
forwarding-class best-effort {
loss-priority low code-point be;
loss-priority high code-point af21;
}
forwarding-class expedited-forwarding {
loss-priority high code-point af21;
loss-priority low code-point be;
}
forwarding-class assured-forwarding {
loss-priority low code-point af11;
loss-priority high code-point af11;
}
forwarding-class network-control {
loss-priority low code-point nc1;
loss-priority high code-point nc1;
}
}
}
user@router> show class-of-service ... Code point type: inet-precedence Alias Bit pattern af11 001
af21 010 af31 011 af41 100 be 000 cs6 110 cs7 111 ef 101 nc1 110 nc2 111 -- Exhibit -
Click the Exhibit button.
Traffic with the IP precedence value af21 ingresses the router and should be rewritten with the same
value as it egresses; however, this traffic is rewritten to a different value.
Referring to the exhibit, what is the source of this problem?
A. The BA classifier is assigning the traffic to the best-effort queue with a high loss priority.
B. The BA classifier is assigning the traffic to the expedited forwarding queue with a low loss priority.
C. The BA classifier is assigning the traffic to the best-effort queue with a low loss priority.
D. The BA classifier is assigning the traffic to the expedited forwarding queue with a high loss priority.
Answer: B

JN0-694問題と解答   

NO.4 -- Exhibit --
user@switch# show vlans
ws {
vlan-id 23;
interface {
ge-0/0/12.0;
ge-0/0/6.0;
} dot1q-tunneling; no-mac-learning; } -- Exhibit -
Click the Exhibit button.
Referring to the exhibit, an administrator notices that all traffic is flooded out of all the ports in VLAN
ws.
What would cause this problem?
A. no-mac-learning is enabled on the interface.
B. Spanning tree is disabled.
C. Unicast destinations are flooded out of all ports.
D. dot1q-tunneling is enabled on the VLAN.
Answer: A

JN0-694 vue   

成功することが大変難しいと思っていますか。IT認定試験に合格するのは難しいと思いますか。今JuniperのJN0-694独学書籍のためにため息をつくのでしょうか。実際にはそれは全く不要です。IT認定試験はあなたの思い通りに神秘的なものではありません。我々は適当なツールを使用して成功することができます。適切なツールを選択する限り、成功することは正に朝飯前のことです。どんなツールが最高なのかを知りたいですか。いま教えてあげます。JPexamのJN0-694独学書籍が最高のツールです。この問題集には試験の優秀な過去問が集められ、しかも最新のシラバスに従って出題される可能性がある新しい問題も追加しました。これはあなたが一回で試験に合格することを保証できる問題集です。

我々の承諾だけでなく、お客様に最も全面的で最高のサービスを提供します。JuniperのJN0-694独学書籍の購入の前にあなたの無料の試しから、購入の後での一年間の無料更新まで我々はあなたのJuniperのJN0-694独学書籍に一番信頼できるヘルプを提供します。JuniperのJN0-694独学書籍に失敗しても、我々はあなたの経済損失を減少するために全額で返金します。

JN0-694試験番号:JN0-694問題集
試験科目:Enterprise Routing and Switching Support, Professional (JNCSP-ENT)
最近更新時間:2017-01-03
問題と解答:全52問 JN0-694 日本語版問題集
100%の返金保証。1年間の無料アップデート。

>> JN0-694 日本語版問題集

 

JPexamは最新の400-351問題集と高品質の70-339問題と回答を提供します。JPexamのP_ADMSEC_731 VCEテストエンジンとC_THR86_1608試験ガイドはあなたが一回で試験に合格するのを助けることができます。高品質のC-THR82-1608 PDFトレーニング教材は、あなたがより迅速かつ簡単に試験に合格することを100%保証します。試験に合格して認証資格を取るのはそのような簡単なことです。

記事のリンク:http://www.jpexam.com/JN0-694_exam.html